Lenze SX-1 - Operating Mode Notes

6/2 —_______________
Notes - Remote Mode
Program execution is monitored using input ES:
program execution is interrupted if this contact is opened; movement is stopped at
maximum deceleration. When ES is re-activated, the remaining distance is firsttravelled,
and then program execution is continued.
Notes - Manual External - Software V 4..00
Inthis mode, you may movetheaxisin eitherdirectionandtothe Home position (with inputs
E5-E8). For each direction there is one input: E5 controls movement to the right, and E6
to the left. With the additional input E7, you may obtain the Fast speed.
NOTE:
To finish Fast movements, open E7 first, or you will start a „Home“ sequence.
Notes - Automatic External - Software 4.00
Automatic -Single Step - SS
The signal on E5 is read dynamically and statically, i. e. the instruction is initiated on the
rising edge.
Automatic - Continuous - FS
The program is started when the input E5 is activated, and stopped when the signal is
removed. Positioning movements are stopped at 100% deceleration. When the input is
re-activated, firstly the remainder of the positioning instruction is executed using program
data, and then the remaining instructions are carried out.
Selection of manual mode causes the program to be re-started from the beginning when
re-starting in the automatic mode.
6/7
Lanze