Lenze SX-1 - Default Chapter; Table of Contents

1. Contents
_Page
1. Contents 1/1
2. Index 2/1
3. General Information
3.0 Introduction 3/0
3.1 Positioning System SX-1 3/1
3.1.1 Layout oftheSX-1 3/1
3.1.2 Technical Data for the SX-1 3/2
3.2 Userlerminal PT-1 3/4
3.2.1 Layout of the PT-1 3/5
3.2.2 Display 3/6
3.2.3 Keyboard 3/7
3.2.4 Technical Data for the PT-1 3/11
4. SX-1 Operating Modes - Over View 4/1
4.1 Remote Gontroller 4/2
4.1.1 Manual-Remote Mode 4/2
4.1.2 Auto-Remote Mode 4/2
4.1.3 Test Mode 4/2
4.2 Manual-External Mode 4/2
4.3 Automatic-External Mode 4/2
4.4 Manual-Remote Operation 4/3
5. Installation
5.1 Dimensions, Mounting and Ventilation 5/1
5.2 Power Supply Voltage 5/3
5.3 Interface Gonneotions 5/4
5.3.1 Parallel Connector Xl (Inputs/Outputs) V5.XX 5/5
5.3.1 Parallel Connector Xl (Inputs/Outputs) V4.XX 5/7
5.3.2 Drive Control Gonneotor X2 5/9
5.3.3 Serial Interface X3 (PT-1 Connection) 5/12
5.3.4 Inoremental Encoder Connection X4 5/13
5.3.4 Absolute Encoder Gonneotion X4 5/14
5.3.4/1 Option: I/O Expansion EA-4 5/15
5.3.4/x Option: I/O Expansion EA-4 5/16
5.3.4/2Description of EA-4 5/17
5.3.5 SX-1 Internal Adjustements 5/18
Axis Controller Module SX-1/21 5/22
Encoder Module Installation 5/23
Encoder Module FB-1 (Inoremental) 5/24
Encoder Module FB-2 (Absolute) 5/25
____ 1/1
Lenze