Lenze SX-1 - 4.1 Remote Control; 4.2 Manual-External; 4.3 Automatic-External

4.1-4.3
4.1 Remote Control
In the Remote modes, the control signais are provided via the Serial Interface Connector
X3. You may use either the PT-1 Terminal, or a Host Computer (either an Industrial
Computer or a PC). There are extra instruetions tor DNC Operation.
There are two modes of Remote Operation: „Manual-Remote“ and „Auto-Remote“
4.1 .1 Manual-Remote (see chpt. 4.4, page 4/3)
In this mode, manual control is possible with the following facilities:
• Jog in both direetions at two speeds (defined by Parameters 7 and 8)
• Jog tor preset distanees (Ineremental)
• Jog to a program med position or distance
• Home
4.1.2 Auto-Remote
In this mode, program operation and axis movement is controlled by Start and Stop
commands from the PT-1 or other computer.
You can:
• Seleet the program number
• Run the program in Single-Step mode (V 4.XX Software only) (Step)
• Run the program in Consecutive (sequential) mode from beginning to end (Auto)
For futher information see Chapter 8.6
4.1.3 Test Mode
In this mode, the Controller operates without the closed Position Loop.
The Manual and Automatic functions are still available (see Chapter 6.1.1)
Warning: There is no position and servo monitoring in this mode, and control is not
therefore guaranteed.
4.2 Manual-External
In this mode it is possible, without the PT-1, to jog the axis in both direotions at two
speeds, (V 4.0 only) and to Home (Reference), using external switches. The control
signals are provided via the Parallel Interface Connector Xl.
4.3 Automatic-External
In this mode, program execution is started and stopped by lnputs (Xl), e. g. from a
supervisory controller or PLC. The program is selected by Parameter PO „PRG.NR“
For further information and selecting these modes, see Chapter 6.2.
4/2 ________
Lanze