Lenze SX-1 - 7.4 Parameter Limits

7.4
7.4 Parameter Limits
Limits of Ranges for Ski
On entering Parameters, the allowable limits may be exceeded. In the first line of the
PT-1 display, the following reports may appear:
limit exceeded
limit not reached
gain factor KV out ot range
incremental velocity too high
calculation of tollowing error out of range
0:
5:
G speed Vmax. • Resol • T c 30 000 000
(PS‘ Pl P4)
5 Following
Error
Vmax. Resol
<445 000
KV 2
P5•Pl
P 18
V gain 26,7 < V max.‘ Resol
<1 744 830
Vmax.V‘KVO
(PS •P1
P3• P16)
Whilst the reports A, 0 or 5 appear on the display, the diagnostic report
„Data Not Sent““ also appears. The parameter data is unacceptable.
4 . • •=:.. : %
4&+k..»».~S :4 <9-s4\ .> 4:» «-:444.<,4?4‘ ••.~.:*.: 4:4< a.k::44“
-N
1
Attention:
Parameters which include „out of range“ values may become „lost“. An error message E27
„parameter values deleted“ occurs, and detault values are loaded.
Attention:
5
Operation with detault values is not possible: it this occurs, check all Parameter
data with respect to the limits, and re-enter as required.
4~.~.~‘o.:¾4‘4 *~
¾ .3&~: 4<~~t ~. ~
7/33
Note:
r
44
tanze