Lenze SX-1 - Program Selection and Mode Switching

8.6
Program number selection and choice ot
Single Step (S-ST) or Continuous (Auto)
running mode may only be pertormed
when a Program is not running.
First choose a Program number.
Move the cursor to P using the MODE
key, press ENTER, and the old Program
number is deleted.
Enter a new Program number (e. g. 6)
Save the number with the ENTER key.
Now program number 6 may be started.
The change from „Auto“ to „Step“ mode
can only be made after entering a key
code number.
AR >P_ <FS
AR->P_ 6FS
AR P000006 < FS
Ii
Cursor
Move the cursor to „Auto“ using the
MODE key, and use the ENTER key to
select:
„Auto“ = Continuous Program Operation
„Step“ = Single Step Program operation
The START key is used to start each
instruction in the „Step“mode.
(For turther details, see also „Auto Re -
mote“ mode, Chapter 4.1 .2)
8/35
Lanze