Lenze SX-1 - Page 41

5.3.2
• Pin 10: Servo Power On
When the input is active, the Controller is enabled and the Reference signal is acti -
vated at zero until movement takes place. When the input is not active, the control
automatically terminates the movement.
Input - Servo Power ON
The input at X2 pin 10 is used for instant interruption of the program and movement.
When open:
- The Reference is zeroed instantly (Actual = Required Position)
- Servo Enable and Ready Outputs are opened
- Error E06 (power loss) is reported
- Ihe following error monitor is cancelled
When closed:
- E06 is cancelled
- Servo Enable and Ready Outputs are restored
- An interrupted program is restarted with a positive edge on E5
- An interrupted automatic movement is completed
- An interrupted manual movement must be restarted with the key
5/11
Lanze