Lenze SX-1 - Encoder Module Jumper Settings; Selection of multiplication for the Incremental Encoder; Drive Enable and NC Ready Settings

<5~3~5
• Seleotion of multiplication tor ihe Inoremental Encoder
At the Encoder module, the pulse count may be multiplied by one, two or four. This is
selected by J1, J2 and J3 on the Encoder module.
J1 J2 J3
*4 open Jumper open
*2 open open Jumper
*1 open Jumper Jumper 1
Delivery state: open Jumper open
Drive Enable and NC Ready
The outputs for Drive Enable and NC Ready may be set tor active high and active 10w. This
may be altered on the SX-1 card by Jumpers J9, JIO and J1 1, J1 2.
• Seleotion for Drive Enable
D
Drive Enable active „L“
Drive Enable active „H“
J1O
Jumper
open
J9
open
Jumper
r
Delivery state active „high“ open Jumper
• Seleotion tor NC Ready
J12 Jil
INC Ready active „L“ Jumper open
NC Ready active „H“ open Jumper j
Delivery state active „high“ open Jumper
5/20
Lanze