Lenze SX-1 - P9-P11 Software Limits and Offset; P 9-P11 Software Limits and Offset

71.2
P 9: Software Limit of movement left (Lim -)
P1O: Software Limit of movement right (Lim +
)
Units for P9 and P1O: Distance Units (mm, inch, degrees)
Range: P9 0 ... - 99999.999 (Lim -)
P1O 0...+99999.999(Lim+)
These limits of movement are „software limit switches“, which should be placed before the
„hardware limit switches“. In automatic mode, a movement is not started if calculation
shows that the end point is beyond these limits. In the manual modes, you can jog up to
these limits.
The left limit is given as a negative number, and the right limit as a positive number. When
the values ±99999.999 are entered, there are no limits. Thus you are able to program limits
relevant to the direction of movement, for example:
Lim- -0.lmm
Lim+ +0
Limit Home Limit
switch Lim - Position Lim + switch
P1o
Ph: Zero Offset (Home Position Offset)
(Oftset)
Units tor Pl 1: Distance Units
This is used to shift the zero point with respect to the Home position tor programmed
movements. The software limit switches P9 and Pl 0 always refer to the true zero (Home)
position.
7/8
Offset zero
po• t
Pl 1
Home Position
/ (Reference Null Point)
Lenze