Safety
4 BPS 34 Leuze electronic
2 Safety
The bar code positioning systems of the BPS 34 series and the MS 34 10x modular
connector hoods have been developed, produced and tested subject to the applicable safety
standards. They correspond to the state of the art.
2.1 Intended use
Bar code positioning systems of the BPS 34 series are optical measuring systems which use
visible red laser light to determine the position of the BPS relative to a permanently mounted
bar code tape.
The modular connector hoods MS 34 103/MS 34 105 are intended for the easy connection
of bar code positioning systems of type BPS 34 in a PROFIBUS system.
The modular service display MSD 1 101, which is optionally available, displays operational
data of the BPS 34 and is used as a simple means of access to the service interface of the
MS 34 105.
Areas of application
The BPS 34 bar code positioning systems are designed for the following areas of applica-
tion:
• High-bay storage devices: Positioning in the travel and lifting axes
•Crane bridges and trolleys
• Side-tracking skates
•Telpher lines
•Elevators
Attention
For UL applications, use is only permitted in Class 2 circuits in accordance with the NEC
(National Electric Code).
CAUTION
Observe intended use!
Only operate the device in accordance with its intended use. The protection of per-
sonnel and the device cannot be guaranteed if the device is operated in a manner not
complying with its intended use.
Leuze electronic GmbH + Co. KG is not liable for damages caused by improper use.
Read the technical description before commissioning the device. Knowledge of this
technical description is an element of proper use.
NOTE
Comply with conditions and regulations!
Observe the locally applicable legal regulations and the rules of the employer's liability
insurance association.
To Next Page
Loading...