Leuze electronic BPS 34 - Overview of the GSD Modules

Device parameters and interfaces
48 BPS 34 Leuze electronic
8.1.6 Overview of the GSD modules
Note!
Inputs and outputs are described from the viewpoint of the PROFIBUS master.
Module
Page
Module name Module contents
(P) = Parameter, (O) = Output, (I) = Input
M1
Page 52
Position value
(P) Sign
(I) Position value
M2
Page 53
Resolution (P) Resolution for the position value
M3
Page 54
Static preset
(P) Preset value added to tape value
(O) Preset teach
(O) Preset reset
M4
Page 56
Dynamic preset
(O) Preset teach
(O) Preset reset
(O) Preset value
M5
Page 57
Offset value (P) Offset value
M6
Page 58
Scaling (P) Scaling factor
M7
Page 60
Switching input
(P) Inversion
(P) Mode
(P) Debounce time
(P) start-up delay
(P) Pulse duration
(P) Switch-off delay
(P) Function
(I) State
M8
Page 62
Switching output
(P) Bias level
(P) Selection of the speed limit value
(P) Pulse duration
(P) Switch-on function
(P) Switch-off function
(O) Switching output "PROFIBUS edge"
M9
Page 64
Control
(P) Measurement start mode
(P) Measurement stop mode
(P) Stop timeout
(I) Position control state
(O) Start event
(O) Stop event
(O) BPS standby
M10
Page 66
Measurement value
acquisition
(P) Maximum permitted measurement length
(P) Minimum permitted measurement length
M11
Page 67
Measurement value
preparation
(P) Integration depth
(O) Counting direction for position calculation