Leuze electronic DDLS 200 Series

To Next Page

To Previous Page

Mounting / Installation (all device models)

Leuze electronic DDLS 200 15

TNT 35/7-24V

The following table shows the maximum number of optical transmission paths for cascading.

Bus system

Max. number of optical

transmission paths for

cascading

Comment

PROFIBUS (with retiming) 3

Attention:

PROFIBUS FMS is a multi-master bus

RS 485 (without retiming) 2

INTERBUS 500kBit

(RS 422)

INTERBUS FOC 3 Applies for 500kBit and 2MBit

RIO 3

1) See remarks in the respective chapters of the individual bus systems about the switch position fil-

tered/not filtered depending on the transmission rate.

DH+

Attention:

DH+ may be a multi-master bus

DeviceNet 3

Depends significantly on the configura-

tion of the master and on the require-

ments of the plant (time behavior).

CANopen 3

Ethernet 3

NOTE

The individual delay time of the optical transmission path is specified in the chapters of the

individual bus systems and depends on the type, switch position, and transmission rate.

DDLS200_E.book Seite 15 Mittwoch, 19. Februar 2020 12:22 12

Leuze electronic DDLS 200 Series - Page 17