objects (except read-only objects). The default value is “write”.
Traps are used by the IP Camera to send massages to a management system
for important events or status changes.
Traps for SNMP v1/ v2
Enable Traps
Check the box to activate trap reporting.
Trap address
Enter the IP address of the management server.
Trap community
Enter the community to use when sending a trap message to the management
system.
Trap Option
Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP Camera,
performs software reload.
Click on <Save> button when complete.
To Next Page
Loading...
