6.3.10 Network Failure Detection
Network Failure Detection allows the IP Camera to ping another IP device (e.g.
NVR, VSS, Video Server, etc.) within the network periodically and generates
some actions in case of network failure occurs, for instance, a Video Server is
somehow disconnected.
Being capable of implementing local recording (through Micro SD card) when
network failure happens, the IP Camera could be a backup recording device for
the surveillance system.
You will be able to turn on/off Network Failure Detection in System section.
Default setting is Off.
Detection Switch
Input the IP device address and the period of ping time to ping. The ping time
setting range is from 1 to 99 minutes.
Detection Type
The Administrator can specify alarm actions that will take when network failure
is detected. All options are listed as follows:
Triggered Action (Multi-option)
Enable Alarm Output
Select the item to enable alarm relay output
Record Stream to SD Card
To Next Page
Loading...
