Select the item and the alarm-triggered recording will be saved into your
Micro SD card.
Pre-trigger buffer recording function allows users to check what happened
to cause the trigger. The pre-trigger buffer time range is from 1 to 3
seconds. Select <Upload for __ sec> to set the recording duration after
alarm is triggered. The setting range is from 1 to 99999 seconds. Select
<Upload during the trigger active> to record the triggered video until the
trigger is off.
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be implemented.
Refer to Recording for further details.
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when an alarm is triggered.
Click on the <Save> button to save all the settings mentioned above.
Save
To Next Page
Loading...
