Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and
configure various parameters. When motion is detected, event images will be
sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to cause
the trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount
of images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select <Upload
for __sec> and enter the duration in the blank. The images of the duration will
be uploading by E-mail when the motion event occurs. The setting range is
from 1 to 9999 seconds. Select <Upload during the trigger active> to make
the images keep being uploaded to E-mail during the trigger active until the
event stops. Set the Image frequency as the upload frame rate. The setting
range is from 1 frame to 15 frames.
Send HTTP notification
Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Motion Detection> triggered. When an
alarm is triggered, the notification can be sent to the specified HTTP server.
For instance, if the custom parameter is set as” action=1&group=2”, and the
HTTP server name is” http://192.168.0.1/admin.php”, the notification will be
sent to HTTP server as” http://192.168.0.1/admin.php?action=1&group=2”
when alarm is triggered.
File Name
Enter a file name in the blank, ex. image.jpg. The uploaded image’s file name format
can be set in this section. Please select the one that meets your requirements.
Add date/time suffix
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
To Next Page
Loading...
