Specify the folder which data in USB disks will be backed up. Click 'Browse'
button to select the desired folder.
Select the desired backup type:
Full - One new folder will be created in the specific folder of the USB
disk in the Storage folder, and then all files will be backed up into the
new folder. But if no file changes from last backup, files will not be
backed up. Specific folder of the USB disk is created according to its
model name and the new folder's format is "YYYYMMHHmm".
Incremental - Only changed files will be backed up and files are always
backed up into the specific folder of the USB disk in the Storage folder.
Specific folder of the USB disk is created according to its model name.
This lists any Backup jobs you have defined. If you have not defined any
jobs, the list will be empty. For each job which has been defined, the follow-
ing data is shown:
Name - the name you assigned to this backup job.
Source & Destination - The name of the source and destination de-
vices are shown in the form Source => Destination.
Date/Time - The date and time of the last backup are shown.
Run the selected backup job immediately.
Click this button to stop the selected backup job.
This button will open a sub-window that shows the status of all Backup
jobs.
This button will open a sub-window where you can define a new backup
job.
This button will open a sub-window where you can change the settings of
the selected backup job.
Delete the selected backup job.
View the log of completed backup jobs in a sub-window.
To Next Page
Loading...
