4 Connecting your device
This chapter provides basic instructions for connecting the Wireless Gateway to a
computer or LAN and to the Internet.
In addition to configuring the device, you need to configure the Internet properties of your
computer(s). For more details, see the following sections:
Configuring Ethernet PCs
This chapter assumes that you have already established a DSL/Cable service with your
Internet service provider (ISP). These instructions provide a basic configuration that
should be compatible with your home or small office network setup. Refer to the
subsequent chapters for additional configuration instructions.
Connecting the Hardware
This section describes how to connect the device to the wall phone port, the power outlet
and your computer(s) or network.
Before you begin, turn the power off for all devices. These
include your computer(s), your LAN hub/switch (if applicable),
and the Wireless Gateway.
The diagram below illustrates the hardware connections. The layout of the ports on your
device may vary from the layout shown. Refer to the steps that follow for specific
instructions.
Step 1. Connect the Ethernet cable to LAN Port Connect the supplied RJ45 Ethernet
cable from your PC's Ethernet port to any of the 11n Repeater's LAN Port.
Step 2. Connect the 11n Repeater to your wall-mounted power outlet
To Next Page
Loading...
