If the LEDs do not illuminate as expected, you may need to configure your Internet access
settings using the information provided by your ISP. For details, see Internet Access.
If the LEDs still do not illuminate as expected or the web page is not displayed, see
Troubleshooting Suggestions or contact your ISP for assistance.
Default device settings
In addition to handling the xDSL / Cable modem connection to your ISP, the Wireless
Gateway can provide a variety of services to your network. The device is preconfigured with
default settings for use with a typical home or small office network.
The table below lists some of the most important default settings; these and other features
are described fully in the subsequent chapters. If you are familiar with network configuration,
review these settings to verify that they meet the needs of your network. Follow the
instructions to change them if necessary. If you are unfamiliar with these settings, try using the
device without modification, or contact your ISP for assistance.
We strongly recommend that you contact your ISP prior to
changing the default configuration.
This is the temporary public IP address of the WAN
port on the device. It is an unnumbered interface that
is replaced as soon as your ISP assigns a ārealā IP
address. See Network Settings -> WAN Interface.
Assigned static IP address:
10.0.0.2
Subnet mask:
255.255.255.0
This is the IP address of the LAN port on the device.
The LAN port connects the device to your Ethernet
network. Typically, you will not need to change this
address. See Network Settings -> LAN Interface.
DHCP (Dynamic
Host Configuration
Protocol)
DHCP server enabled with the
following pool of addresses:
10.0.0.3
through
10.0.0.250
The Wireless Gateway maintains a pool of private IP
addresses for dynamic assignment to your LAN
computers. To use this service, you must have set up
your computers to accept IP information dynamically,
as described in Configuring Ethernet PCs.
To Next Page
Loading...
