LevelOne WRE-6001 - Page 37

37
Field
Description
Enable SSID
Broadcast
Broadcast or Hide SSID to your Network.
Default: Enabled
Enable Wireless
Isolation
Isolate your Network.
Default: Disabled
SSID
Specify the network name.
Each Wireless LAN network uses a unique Network Name to identify
the network. This name is called the Service Set Identifier (SSID). When
you set up your wireless adapter, you specify the SSID. If you want to
connect to an existing network, you must use the name for that
network. If you are setting up your own network you can make up your
own name and use it on each computer. The name can be up to 20
characters long and contain letters and numbers.
Mode
Specify the WLAN Mode to 802.11b mode, 802.11g mode, 802.11b/g
mode, 802.11n mode, 802.11n/g mode or 802.11b/g/n mode
Channel
Choose a Channel from the pull-down menu.
Band Width
Choose a Band Width from the pull-down menu.
Max
Transmission
Rate
Select the Max Transmission Rate from the drop-down list
Security Options
Configure the Encryption to None, WEP, WPA-PSK[TKIP] , WPA2-
PSK[AES] or WPA-PSK/WPA2-PSK AES
Security
Encryption(WEP)
Authentication Type: Automatic or Shared Keys
Encryption Strength: 64 bits or 128 bits
Security
Encryption(WEP)
Key
Select and configure Key 1, Key 2, Key 3 or Key 4
Security
Options(WPA-
PSK)
Enter the Pre-Shared Key
Security
Options(WPA2-
PSK)
Enter the Pre-Shared Key
Security
Options(WPA-
PSK+WPA2-
PSK)
Enter the Pre-Shared Key