Step 10: Configure for TCP/IP
If you have TCP/IP available on your network, we recommend that you
assign an IP address to the printer.
Assigning a printer If your network is using DHCP, an IP address is automatically assigned
IP address
Note: Instructions for other
methods of setting the IP
address are in the online
documentation on the
drivers CD that shipped with
your printer. Launch the CD,
and then click View
Documentation
Network
Printer Install.
after you connect the network cable to the printer.
1 Look for the address under the “TCP/IP” heading on the
network setup page you printed in “Printing a network setup
page” on page 64.
2 Go to “Verifying the IP settings” on page 67 and begin with
step 2.
If your network is not using DHCP, then you must manually assign an
IP address to the printer.
One of the easiest ways is to use the operator panel:
1 Press Menu until you see Network Menu, and then press
Select.
2 Press Menu until you see Standard Network, and then press
Select.
Standard Network appears if you purchased a printer with a
network port on the printer system board. If you have a MarkNet
print server installed in the option card, you see Network
Option 1.
3 Press Menu until you see Std Net Setup (or Network 1
Setup), and then press Select.
4 Press Menu until you see TCP/IP, and then press Select.
5 Press Menu until you see Set IP Address, and then press
Select.
Configure for TCP/IP
66
To Next Page
Loading...
Need help?
General
