6 Press Return to exit the menus when finished.
7 Print a Menu Settings page and verify that your serial
parameters are correct. Keep this page for later use.
a
b
c
Press Menu until you see Utilities, and then press
Select.
Press Menu until you see Print Menus, and then press
Select.
Look under the Standard Serial (or Serial Option X if
you installed a serial interface card) heading to find the serial
parameters.
Installing a printer driver You must install a printer driver on the computer that is connected to
the printer.
1 Insert the drivers CD. It launches automatically. If the CD does
not launch automatically, click Start Run, and then type the
following in the Run dialog box:
D:/Setup.exe.
2 Click Install Printer Software.
3 Click Agree to accept the Printer Software License Agreement.
4 Select Local printer install, and then click Next.
5 Check the box next to the printer you are installing, and then
select the communications port (COM1 or COM2) you want to
use.
6 Click Finish to complete the printer software installation.
Setting parameters After the printer driver is installed, you must set the serial parameters
in the communications
in the communications port assigned to the printer driver.
(COM) port
The serial parameters in the communications port must match exactly
to the serial parameters you set in the printer.
1 Click Start Settings Control Panel, and then double-click
System.
2 On the Device Manager tab, click + to expand the list of available
ports.
Install drivers for local printing
62
To Next Page
Loading...
Need help?
General
