Change history
Change history
October 24, 2018
• New FRUs (41X2513, 41X2514, and 41X2518) were added to the Electronics 1 Parts catalog. Notes regarding
compatibility were also added.
• The Control panel (MX421, MX521, and MX522) Parts catalog was revised. FRU PN 41X2231 was changed
to 41X2524. FRU PN 41X2226 was changed to 41X2525.
• The Imaging (MX321, MX421, and MX521) Parts catalog was split into two parts. New FRUs (41X2519 and
41X2520) were added to part 1. Notes regarding compatibility were also added.
• New Imaging (MX321, MX421, and MX521) 2 Parts catalog was added. New FRUs (41X2522, 41X2523) were
added. FRU PN 41X1314 was changed to 41X2528. Notes regarding compatibility were also added.
• Fax symptoms section was added.
August 17, 2018
• New FRUs (41X2540 and 41X2500) were added to the Control panel (MX421, MX521, and MX522) Parts
catalog.
• 41X1351 FRU was deleted from the Control panel (MX421, MX521, and MX522) Parts catalog.
August 2, 2018
• Date security notice was updated.
• Software CD and Smart card were added to the Miscellaneous Parts catalog.
July 6, 2018
• Supported paper sizes information was updated.
• Output device diagnostics section under Service menus was deleted.
May 4, 2018
• Multifeed calibration was removed from the Scanner diagnostics menu.
• Controller calibration description was updated.
• An installation note for performing Controller calibration was added to the Flatbed scanner removal.
• For the right cover removal, an image was added showing how to open the controller board access cover.
• Printhead assembly adjustment was updated to include a note referring to the Registration adjust procedure.
April 27, 2018
• Reference to print defects guide on the Repeating defects check was removed.
• Reference to second transfer roller on the Enable edge-to-edge (printing) was removed.
• Image for Printhead removal was revised.
• Scanner front cover FRUs (41X2444 and 41X1345) were removed from the Control panel parts catalog
assemblies.
7017-2xx, -4xx, -6xx
Change history
21