8 Remove the screw (A) and the sensor.
A
9 Remove the cable JACM1.
Pick roller assembly removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 211.
3 Remove the rear cover. See “Rear door and cover removal” on page 273.
4 Remove the power supply. See “Power supply removal” on page 260.
5 Remove the duplex. See “Duplex assembly removal” on page 262.
6 Position the printer on its right side.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
7 Using needle‑nose pliers, block the roller (A) to prevent it from rotating.
7017-2xx, -4xx, -6xx
Parts removal
268
To Next Page
Loading...
