Pick roller clutch removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 211.
3 Remove the rear cover. See “Rear door and cover removal” on page 273.
4 Remove the power supply. See “Power supply removal” on page 260.
5 Remove the duplex assembly. See “Duplex assembly removal” on page 262.
6 Using needle‑nose pliers, block the roller (A) to prevent the shaft from rotating.
7 While blocking the roller, remove the screw (B).
A
B
8 Pull out the pick roller assembly clutch, and then cut the cable to remove it.
Installation note: Route the cables as shown.
7017-2xx, -4xx, -6xx
Parts removal
221
To Next Page
Loading...
