Lexmark MB2546 - Sensor (Trailing Edge) Removal

b Apply RheoGel 793 to the point of contact between the bracket (A) and cam.
c Apply RheoGel 793 to the point of contact to the lower edge (B), where the wiper bracket glides.
B
A
Sensor (trailing edge) removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear cover. See “Rear door and cover removal” on page 273.
3 Remove the power supply. See “Power supply removal” on page 260.
4 Remove the duplex assembly. See “Duplex assembly removal” on page 262.
5 Position the printer on its left side.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
6 Open the controller board access cover.
7 Disconnect the cable JACM1, and then release the cable.
7017-2xx, -4xx, -6xx
Parts removal
267