Troubleshooting
230
The finisher does not
offset the print job as
requested.
You’ve selected both offsetting
and
stapling for the job.
The finisher cannot staple
and
offset
a print job. If both functions are
selected, the printer staples the job,
but does not offset it.
Pages are not stapled. The stapler is not installed or is
not installed correctly.
Reinstall the stapler.
Refer to the
User’s Reference
for
instructions on removing and
installing the stapler.
The stapler is out of staples. Insert a new staple cartridge.
Refer to the
User’s Reference
for
instructions on installing a new
staple cartridge.
The stapler is jammed. Check the stapler for a staple jam.
Refer to the
User’s Reference
for
information on clearing a staple jam.
The stapler is not primed. Prime the stapler.
Refer to the
User’s Reference
for
information on priming the stapler.
Staples are not properly
positioned in the stapler.
Prime the stapler.
Refer to the
User’s Reference
for
information on priming the stapler.
You are trying to staple too
many sheets.
The finisher can staple up to 50
sheets of 20 lb paper. If you attempt
to staple a larger stack of paper, the
finisher ejects the stack without
stapling it.
Reduce the number of pages in the
staple job.
Finisher problems (continued)
Symptom Cause Solution
To Next Page
Loading...
