Troubleshooting
232
A printer message says
that all linked bins are
full, but bin 1 is empty.
Bin 2 (the default bin for all
stapled and offset jobs) is full.
The finisher stacks all stapled jobs
and all offset jobs in bin 2. If bin 1
and bin 2 are linked and bin 2 is full,
the printer reports that bin 1 is full
also.
To clear the message, remove the
stack of paper from bin 2. The
printer can then receive additional
stapled or offset jobs.
The transport unit falls
from the top of the
printer when you pull
away the finisher.
The guide rail attaching the
finisher to the printer is not
properly installed.
Reinstall the guide rail. When
properly installed, the guide rail
prevents you from pulling the
finisher too far away from the printer.
Refer to the
Setup Guide
for detailed
installation instructions.
Finisher problems (continued)
Symptom Cause Solution
To Next Page
Loading...
