Changing printer settings
45
Staple Prime Src
Note:
Staple Prime Src is only
displayed when a finisher
option is installed.
= Tray 1*
= Tray 2
= Tray 3
= Tray 4
When a staple cartridge is replaced or a staple jam is cleared,
the printer must prime the stapler by stapling several staples
into a sheet of paper. Use this setting to specify the paper
source you want the printer to draw from when it is priming the
stapler.
Note:
Only installed paper sources are displayed.
Hole Punch
Note:
Hole Punch is only
displayed when a finisher
option is installed.
= Off*
= On
Select On to punch holes in each print job sent to the printer.
Note:
Setting Hole Punch to On makes it the default for the
printer. We recommend setting Hole Punch to Off and selecting
Hole Punch from the printer driver.
Offset Pages
Note:
Offset Pages is only
displayed when a finisher
option is installed.
= None*
= Between Copies
= Between Jobs
Use the Offset Pages setting to offset entire print jobs or copies
of the same print job. Select Between Jobs to offset between
separate print jobs. Select Between Copies to offset between
copies of the same print job.
Finishing Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
