Changing printer settings
47
Factory Defaults = Restore
= Do Not Restore
If you choose Restore:
• All downloaded resources (fonts, macros, and symbol sets)
in printer memory (RAM) are deleted. (Resources residing in
flash memory or on the hard disk option are unaffected.)
• All menu settings are returned to the factory defaults except:
– Display Language (Setup Menu) which is the operator
panel display language.
– All settings in the Parallel Menu, Serial Menu, Network
Menu, Infrared Menu, LocalTalk Menu, USB Menu, and
Fax Menu.
Format Flash
Note:
Format Flash is only
displayed when a flash
memory option is installed,
and is neither defective nor
Read/Write or Write protected.
= Yes
= No
Formatting the flash memory option deletes all resources (fonts,
macros, and symbol sets) stored in flash memory, and prepares
the flash memory card to receive new resources.
Warning:
If you select Format Flash and press
Go
, any data
stored in flash memory is lost. Do not turn off the
printer while the flash is formatting.
Defragment Flash
Note:
Defragment Flash is
only displayed when a flash
memory option is installed,
and is neither defective nor
Read/Write or Write protected.
= Yes
= No
Defragmenting the flash memory option transfers all undeleted
resources stored in flash memory to printer memory and then
reformats the flash memory option. When the format operation
is complete, the undeleted resources are loaded back into flash
memory.
37 Insufficient Defrag Memory
is displayed if printer memory is
too full to perform the Flash Memory Defragment operation.
Refer to the
User’s Reference
for more information on printer
messages.
Warning:
Do not turn off the printer while the flash is
defragmenting.
Utilities Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
