Changing printer settings
48
Format Disk
Note:
Format Disk is only
displayed when a hard disk
option is installed, is neither
defective nor Read/Write or
Write protected, and Job
Buffer Size is not set to 100%.
= Yes
= No
Formatting the hard disk option deletes all resources stored on
the hard disk and prepares it to receive new resources.
If you select Format Disk and press
Go
, any data stored on the
hard disk option is lost. Do not turn off the printer while the hard
disk is formatting.
Job Acct Stat
Note:
Job Acct Stat is only
displayed when a hard disk
option is installed, is neither
defective nor Read/Write or
Write protected, and Job
Accounting in the Setup Menu
is set to On.
= Print
= Clear
Select Print to print a list of statistics for a defined number of the
most recent print jobs. (The number of jobs is determined by
the value of the Job Acct Limit menu item in the Setup Menu).
The statistics include whether the job printed with or without
errors, the time required to print the job, the size (in bytes) of
the job, the requested paper size and paper type, the total
number of printed pages, and the number of copies requested.
Select Clear to delete all accumulated job statistics from the
hard disk option.
Clearing Job Accounting Stat
is displayed until
the process completes. See “Tracking job statistics” on
page 170 for more information.
Hex Trace Press
Select
to enter Hex Trace mode.
Hex Trace helps isolate the source of a print job problem. With
Hex Trace selected, all data sent to the printer is printed in
hexadecimal and character representation. Control codes are
not run.
To exit Hex Trace, turn the printer off or reset the printer. To
reset the printer, press
Menu>
or
<Menu
.
Job Men
u is displayed.
Press
Menu>
or
<Menu
until
Reset Printer
appears on the
second line of the operator panel display. Press
Select
.
Utilities Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
