Changing printer settings
57
Resource Save = Off*
= On
The Resource Save setting determines what the printer does
with downloaded resources, such as fonts and macros, if it
receives a job that requires more memory than is available.
If Resource Save is set to On, the printer retains all permanent
downloaded resources for all printer languages during
language changes and printer resets. If the printer runs out of
memory,
38 Memory Full
appears on the operator panel display.
If Resource Save is set to Off, the printer retains permanent
downloaded resources only until memory is needed. Then it
deletes those resources stored for the inactive printer language.
Download Target
Note:
Download Target is only
displayed when a formatted
flash memory option or hard
disk option is installed, is
neither defective nor Read/
Write or Write protected, and if
Job Buffer Size is not set to
100%.
= RAM*
= Flash
= Disk
The Download Target menu item specifies the storage location
for downloaded resources, such as fonts and macros. (If neither
a flash memory option or a hard disk option is installed, all
downloaded resources are automatically stored in printer
memory (RAM).)
Storing downloaded resources in flash memory or hard disk is
permanent storage rather than the temporary storage that RAM
provides. You can add resources to flash memory or to the hard
disk until the option is full. Use MarkVision to download
resources to the printer.
Note:
If
51 Defective Flash
or
61 Defective Disk
appears when
the printer is turned on, or during format and write operations,
refer to the
User’s Reference
for more information.
Setup Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
