MAKE SURE THE PRINTER POWER IS ON
Make sure the printer is connected to a power source and is turned on.
MAKE SURE THAT THE NETWORK IS OPERATING PROPERLY
• Try to access other computers on the network.
• Make sure all switches, hubs, and other connecting devices are turned on.
MAKE SURE THE PRINTER HAS VALID NETWORK SETTINGS
Print a network setup page from the printer and check the following. See the “Networking” section of the User's
Guide for instructions on how to print a network setup page.
• Verify that the IP address is correct for your network.
• Verify that the gateway is correct.
• Verify that the network mask is the same as the network mask used for other computers and printers on your
network.
Cannot print to the network printer
C
HECK THE ETHERNET CABLE
• Check the Ethernet cable and the Ethernet connectors at both ends for any obvious damage.
• Firmly plug one end of the Ethernet cable into the printer. Firmly plug the other end of the Ethernet cable into
the network hub or wall connection.
• Try using a different cable. Damage to the cable may not be obvious.
MAKE SURE THE PRINTER POWER IS ON
Make sure the printer is connected to a power source and is turned on.
MAKE SURE THAT THE NETWORK IS OPERATING PROPERLY
• Try to access other computers on the network.
• Make sure all switches, hubs, and other connecting devices are turned on.
UNINSTALL AND REINSTALL THE SOFTWARE
See the “Reinstalling the printer software” section of the User’s Guide.
Embedded Web Server does not open
Try one or more of the following:
CHECK THE NETWORK CONNECTION
Make sure the printer and computer are turned on and connected to the same network.
Troubleshooting 174
To Next Page
Loading...
Need help?
General
