Lexus Supports ASE Certification
Page 1 of 2
Title:
INITIALIZATION OF ADVANCED
PARKING GUIDANCE SYSTEM
Models:
’07 LS 460
Technical Service
Information Bulletin
September 22, 2006
PD068-06
The Advanced Parking Guidance System assists the driver during parking and parallel
parking by displaying an image of the area behind the vehicle and controlling the
steering wheel with the vehicle in reverse.
As a result of removing the DCC fuses or disconnecting the battery, the power source to
the steering angle sensor is cut off. When the DCC fuses are reinstalled or the battery
terminal is reconnected, the rear view monitor will be operative, but it cannot assist back
up parking operation because the center position recognized by the steering angle
sensor may not be initialized.
Initialize the Advanced Parking Guidance System after installing the DCC fuses during
Pre-delivery Service (PDS) at the dealership.
NOTE:
Any time the battery terminal has been disconnected, the Advanced Parking Guidance
System MUST be re-initialized.
S 2007 model year LS 460 vehicles.
OP CODE DESCRIPTION TIME OFP T1 T2
N/A Not Applicable to Warranty – – – –
1. Start the engine.
2. Check if the Advanced Parking
Guidance System is operative
by shifting the shift lever to the
“R” position.
“System initializing.” appears on
the rear view monitor as shown in
the illustration.
3. Shift the shift lever to the “P” position
and turn the steering wheel lock
to lock.
PRE-DELIVERY SERVICE
Introduction
Applicable
Vehicles
Warranty
Information
Initialization
Procedure
Before Initialization
To Next Page
Loading...
