INITIAL CALIBRATION OF COMPASS DURING PDS – PD067-06 September 22, 2006
Page 3 of 3
4. Depress the brake pedal and press
the engine START/STOP switch once
to start the engine.
5. Push and hold the “AUTO” switch on
the mirror for about 9 seconds until
“CAL” appears on the display.
6. Drive the vehicle slowly at 5 mph
(8 km/h), or less, in a circle until the
direction is displayed. If there is NOT
enough space to drive in a circle, turn
the car around as shown, doing two
three-point turns in succession.
After driving in 1 to 3 circles in the
above method, “CAL” disappears and
calibration is complete.
NOTE:
S Do NOT perform calibration of the
compass in a place where the
Earth’s magnetic field is subject to
interference by artificial magnetic
fields (underground parking, under a
steel tower, between buildings, roof
parking, near a railroad crossing,
near a large vehicle, etc.)
S During calibration, do NOT operate
electric systems (moon roof, power
windows, etc.) as they may interfere
with the calibration.
Compass
Calibration
Procedure
(Continued)
To Next Page
Loading...
