INITIAL CALIBRATION OF COMPASS DURING PDS – PD067-06 September 22, 2006
Page 2 of 3
1. With foot OFF of the brake pedal,
press the engine START/STOP button
twice to switch to “IG-ON” mode.
2. Push and hold the “AUTO” switch
on the mirror for 6 seconds until the
zone number appears on the
compass display.
NOTE:
Pushing the “AUTO” switch for
3 seconds turns the compass display
ON or OFF.
3. Once the zone appears, push the
“AUTO” switch to select the number of
the zone where the vehicle is located.
See the map below for
zone reference.
Hawaii: 6
Puerto Rico: 11
A. Samoa: 5
Guam: 8
Saipan: 8
North America
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
6
Compass
Calibration
Procedure
To Next Page
Loading...
