TIRE PRESSURE WARNING VALVE/SENSOR ACTIVATION – PD072-06 September 22, 2006
Page 4 of 5
5. Press the “DISP” switch on the
steering wheel and check that the tire
pressures of all 5 tires is displayed on
the multi-information display.
NOTE:
S The tire pressure display is NOT
shown until all tire pressure warning
valve/sensors are activated.
S If “Check Tire Pressure System” or
“CHECKING” (which means the tire
pressures are being measured) is
displayed, repeat step 3. If step 3 is
performed and the tire pressures are
still NOT displayed, turn the tires 90
to 270 degrees.
S If the above steps are performed and
the multi-information display does
NOT show the tire pressures, refer
to the Repair Manual.
6. Adjust all tires (including the spare
tire) to the standard tire inflation
pressure, as indicated on the Tire and
Loading Information Label located
inside the driver’s door jam and
confirm that the Low Tire Pressure
Warning Light is OFF.
NOTE:
S If there is great difference between
the current temperature of the tire
and wheel (for example: shop
temperature) and expected
temperature (for example: outdoor
temperature), this needs to be
considered when adjusting the
tire pressure.
S Adjust the tire pressure when the
tires are cold.
Activation
Procedure
(Continued)
TIRE PRESSURE
33
Includes
Spare
Tire
[psi]
33
33
33
33
Tire and
Loading
Information
Label
To Next Page
Loading...
