Lightware UMX-TP-TX100R - 5 Commands - Quick Summary

Page 40 / 43 Section 5. Commands – Quick summary
5. Commands – Quick summary
Router Status commands
Section
Command
View product type
4.3.1
{I}
View serial number
4.3.2
{S}
View Firmware version of the CPU
4.3.3
{F}
View installed controllers’ firmware
4.3.4
{FC}
View device’s temperature
4.3.5
{ST}
View CPU firmware compile time
4.3.6
{CT}
View installed I/O boards
4.3.7
{IS}
System commands
Section
Command
Query current control protocol
4.4.1
{P_?}
Change RS-232 baud rate
4.4.2
{RS232BAUD=<rate>}
Query RS-232 baud rate
4.4.3
{RS232BAUD=?}
Reload factory defaults
4.4.4
{FACTORY=<f1>;<f2>;…;<fx>}
Set the RS232 operation mode
4.4.5
{RS232=<mode>}
Query the RS232 operation mode
4.4.6
{RS232=?}
Count HDCP keys
4.4.7
{:HDCPTEST<in>@<num>}
Clear HDCP key cache
4.4.8
{:HDCPRESET}
Restart matrix router
4.4.9
{RST}
View error list
4.4.10
{ELIST=?}
Configure remote alerts
4.4.11
{ELEVELSEND#<p>=<0>;<1>;
<2>;<3>;<4>}
Query level of remote alerts
4.4.12
{ELEVELSEND#<p>=?}
Set the priority settings
4.4.13
{VIDEOPRIORITY=<pmode>}
Query the priority settings
4.4.14
{VIDEOPRIORITY=?}
EDID router commands
Section
Command
Save EDID to user memory (Learn EDID)
4.5.1
{<loc1>:<loc2>}
View emulated EDIDs on all inputs
4.5.2
{VEDID}
Watch EDID validity table
4.5.3
{WV<type>}
View EDID header
4.5.4
{WH<loc>}
Download EDID content from the router
4.5.5
{WE<loc>}
Upload EDID content to the router
4.5.6
{WL#<loc>}
Delete EDID from memory
4.5.7
{DE<loc>}