Instruction Manual for TECH-system type 239
______________________________________________________________________________
Page 3 of 39 june 2020 ver. 09
LINAK Danmark A/S - Mønstedsvej 9 8600 Silkeborg - Telefon 86803611 - www.linak.dk
Important information
Important information about LINAK products is presented under the following headers:
Warning! Failure to comply with these instructions may result in accidents leading to serious
personal injury.
NB! Failure to comply with these instructions may result in damage to or destruction of the
product.
Warranty
The LINAK warranty covers manufacturing faults and defects in the products as calculated from the date
of manufacture. Please contact LINAK Danmark A/S for additional information about the warranty period.
The warranty is limited to the value of the LINAK product.
The LINAK warranty shall only apply if the system has been used correctly and has not been opened. The
control box and control unit must not be exposed to violent use. Failure to comply with this requirement
will void the warranty.
Safety instructions
Please read the following safety information carefully. It is essential that everyone who is to connect,
install or use the system receive the necessary information and have access to this instruction manual.
LINAK recommends that the actuators be used for push applications rather than pull applications.
It is essential that everyone who is to connect, assemble or operate the systems receive the necessary
information and have access to this instruction manual.
Before installation, removal or troubleshooting:
• Stop the actuator.
• Disconnect the power supply and remove the mains plug from the socket.
• Free the actuator from any load that may be released during the work.
Before starting:
• Make sure that the system has been assembled as described in this instruction manual.
• Make sure that the current to the control box is correct before connecting the system to a power
supply.
• System connection. The individual parts must be connected before the control box is connected to
mains power.
During operation:
• If the control box emits unusual sounds or smells, disconnect the mains current and any external
batteries.
• Make sure that the cables are not damaged.
• Disconnect the mains cable from mobile equipment before moving same.
• The products can be used both indoors and outdoors.
Classification:
To Next Page
Loading...
Need help?
General
