Instruction Manual for TECH-system type 239
______________________________________________________________________________
Page 30 of 39 june 2020 ver. 09
LINAK Danmark A/S - Mønstedsvej 9 8600 Silkeborg - Telefon 86803611 - www.linak.dk
Once you have made the changes you require, save the new configuration by pressing ARROW UP for at
least 2 seconds.
Parameters
The following parameters can be adjusted as required or desired:
1. Speed: Set the operating speed of the actuators
2. Initialisation speed: Set reduced speed during initialisation operation
3. Start ramp: Set ramp time, Start
4. Stop ramp: Set ramp time, Stop
5. Power limit: Set the max. power limit.
6. Deviation in pulses: Set the max. permissible deviation in pulses
7. Regulation behaviour: Set hard or soft regulation behaviour
8. Error indication: Set activated or deactivated error indication
9. Start conditions: Set the direction the actuators are to run after ERRORS
10. Operating mode: Define whether pulse activating or continuous activating on push is
required
11. Power-on: Set whether the control unit is to perform an automatic
initialisation every time voltage is connected to the control unit.
12. Auto-initialisation: Set the starting point for automatic initialisation
13. Dual pulse mode: Set utilisation of Dual hall pulse feedback.
14. End stop OUT: Set maximum stroke length, OUT.
To Next Page
Loading...
