Troubleshooting
Symptom Possible cause Action
No signal or incorrect
feedback output
Cable damaged Please contact your local LINAK
®
supplier
Wrongly connected Check the wiring
Signal is constantly high/low Run the actuator to fully extended and
retracted positions
Feedback output overloaded Reduce the load according to your chosen
feedback type
Actuator runs in smaller
steps
Insufficient power supply Check the power supply
Load is higher than specified Reduce the load
Actuator cannot hold the
chosen load
Load is higher than specified Reduce the load
For further assistance, please contact your local LINAK supplier�
To Next Page
Loading...
