EasyManua.ls Logo

Linde T 16 - Commissioning: Built-in Charger

Linde T 16
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
6
0
8
0
4
2
5
1
1
-
0
5
0
4
4
3
CEE
GB
CH
US-C
1
2
Daily checks and commissioning checks
Charging the battery with the built-in char-
ger ( from 07/2000 )
Every day the truck is used normally, or every two days in
case of non-intensive use, charge the battery at the end of
the shift.
-
Par
k the t
ruck n
ear a so
cket o
utl
et (22
0 V – 10/
16 A)
.
-
Lower t
he for
ks, tur
n off
the ke
y switc
h, rem
ove the
key.
-
Open t
he bat
tery c
ompartm
ent co
ver (1)
for go
od ven
tila-
tion.
-
Rem
ove th
e plug (
2) fro
m its p
ort , pa
y out th
e wire a
nd
connect the plug to the mains.
-
The ch
arge
r start
s auto
mat
ical
ly, th
e gree
n light (
3)
flashes, the red light (4) comes on and then goes off and
the charger fan is switched on.
-
At th
e end o
f the
normal
charge,
the gre
en ligh
t rema
ins
continuously on, and the fan stops.
-
An eq
ualizat
ion c
harge
starts
automa
tically
15 mi
nutes
later; the green light remains on and the fan is switched
on.
-
If th
e char
ger re
mai
ns con
nect
ed to th
e main
s powe
r
supply, it will restart a charge holding cycle every 48
hours, and the green light flashes.
Commissioning
WARNING:
Do not disconnect the battery connector while
charging (green light flashing).
Problems while charging
If a fault occurs while charging, the red light (4) comes on
and the charger stops.
Proceed as follows to resume a charge cycle after detection
of an anomaly:
-
Disc
onne
ct t
he m
ain
s po
wer
supp
ly
-
Unp
lug th
e batt
ery con
nect
or for at l
east 1 mi
nut
e
-
Reconne
ct the
battery
connect
or, an
d then
plug t
he ma
ins
power supply in.
Please call one of our dealers if the problem persists.
Putting the mains power supply cable away
-
Stow
the ca
ble i
n the
compart
ment
between
the b
attery
box and the chassis.
-
Push t
he mai
ns plug
(2) on
the cab
le int
o the
red saf
ety
support in the battery compartment.
-
Cl
os
e t
he
co
ve
r.
IMPORTANT
The truck will operate only if the plug is replaced correc
tly.
Charger electrical specifications
Mains power supply 220 V 50 Hz*Nominal battery voltage
24 V
Maximum output power 720 W Maximum current 30 A
Charging time 12 h (240 Ah)
*Other voltages/frequencies available to suit electrical
mains power supply in different countries
Special case of Gel batteries
Batteries with a gel electrolyte must always be charged
using a special charger.
https://www.besttruckmanuals.com/

Table of Contents

Related product manuals