Send Command and Get a Response
Pressing SEND causes the command to be sent to the
vehicles ECU. If there is a response to the message, it
will be shown.
The first response returned after the command is sent
is displayed. If there is a lot of traffic on the bus, this
may not be the response to the command you sent. It
may be necessary to resend the command and check
for the correct response.
Pressing the lower right function button next to OK will
return you to the Command Home Screen.
486B10410544F7
OK>
<EDIT
<
SEND>
>MEMORY *0
Advanced Features
57
To Next Page
Loading...
