Rev: 11.13.2017 Page 7
Ground Control TT Leveling OCTP Owner's
Callout Description
A
Jack Buttons - Select Front, Rear, Right and Left jacks to be operated depending on mode.
Jacks available to be operated will be highlighted in blue.
Only the Power Tongue Jack can be operated in Standard Mode. In Manual Mode (Fig. 7), all
jacks are available to be operated (No Power Tongue Jack operation available).
B Up and Down Arrows - Scrolls through options on screen.
C Info - Displays system information, e.g. angle, jack stroke or software version.
D Connected Icon - Press 6 times to program zero point/ wireless configurations.
E Home Icon - Returns screen to home page.
F
Auto Retract - Enters Auto Retract mode to retract all jacks. Power Tongue Jack does not
retract.
G Manual Mode - Enters Manual Mode to manually operate jacks.
H Enter - Push to select various modes.
I Retract - Retracts jacks in several modes. Jacks available will be highlighted in blue.
J Extend - Extends jacks in several modes. Jacks available will be highlighted in blue.
K Reset - Resets to factory default.
L Power Button - Turns touch panel on and off.
M Auto Level - Starts the Auto Level sequence.
N Auto Hitch - Returns trailer to previous hitch height for reconnecting to tow vehicle.
Fig. 4 - Leveling Standard Mode
F
G
I J MK N
H
C
Jack Buttons
in Manual Mode
See Fig. 7
D
E
L
A
B
5. Latch the tow vehicle hitch and connect any wires, chains or sway control that may be equipped between the
tow vehicle and trailer.
6. Press and hold the "DOWN" arrow until the Power Tongue Jack is fully retracted.
NOTE: To utilize the Power Tongue Jack for the hitching process see "Operation - Power Tongue Jack."
Touch Panel Diagram - OneControl Touch Panel
To Next Page
Loading...
Need help?
General
