12
LECTROCOUNT GROUND STRAP KIT
LectroCount Ground Strap Kit
All seat cushions are grounded in a similar manner.
The illustrations on the next page detail the following
seats.
To ground a truck seat:
cab. These seats will typically have pivot points, hinges,
already exist, drill a 9/32” hole in the seat frame.
3. Attach one end of the ground strap to the seat frame
provided.
in the part of the seat frame—above all pivots and
interfere with the ground path between the seat cushion
and the ground strap.
4a. If the seat cushion has a wooden base, use a wood
screw and washer to attach the strap lug to the bottom
of the seat at a point where the seat fabric is attached to
the wood. There must be good contact between the seat
fabric and ground strap lug.
below).
Remove any dirt or oxidation from the ground strap
contact point. Lock washers should penetrate any
paint to ensure a good electrical connection.
Ensure a Good Ground
6
1
2
3
3
5
8
4
9
LectroCount Ground Strap Kit - 82185
Install the LectroCount Ground Strap Kit
before installing the LectroCount register.
. ESD Precaution .
Some truck seats, typically passenger seats, are
not adjustable and do not require grounding.
Grounded Passenger Seats
To Next Page
Loading...
