14
Smith Adapter
LCR-II with LPG
Meter System
LCR-II MOUNTING
Mounting Overview
Typically, the LectroCount LCR-II is mounted directly
require the register be mounted away from the meter.
If the meter is equipped with an external POD pulser,
the LCR-II can be mounted up to 1000 wire feet (304
meters) away from the meter (actual distance depends
Adapters are available for other PD meters such as
includes installation instructions.
Tips for mounting an LCR-II
:
the internal components.
attached to the pulser drive shafts.
and selector switch can be easily operated.
Relieving Internal Pressure
! WARNING
Relieving Internal Pressure Procedure for LPG and NH
3
Meters
relieve product pressure in the system. Product will drain
from the meter system.
7. As product is bleeding from the differential valve, slowly
Repeat this step until the product stops draining from the
on the system.
2. Close the valve on the vapor return line.
3. Close the manual valve in the supply line on the inlet
side of the meter. If no manual valve exists on the inlet
line.
end of the supply line.
Serious injury or death from fire or explosion could result in performing maintenance on an
improperly depressurized and evacuated system.
To Next Page
Loading...
Need help?
General
