3-6 CHAPTER 3: SETTING INTO OPERATION
ALPHA 552
Anchoring to the ground
Once the barfeed system is in place, and perfectly aligned, it should be anchored to the ground to make it
stable. To accomplish this, 8 anchorage points (A) have been provided.
8 anchorage bolts (B) must be furnished by the client (min. M10 x 100 mm / 1/2" x 4").
• Once the anchoring bolts are tightened, check the alignment again, and correct it if necessary.
• Tighten the nuts of the levelling screws.
• Remove the 4 (2+2) screws (C).
B
A
C
C
To Next Page
Loading...
