CHAPTER 8: OPERATION 8-9
ALPHA 552
Part setup: Guiding channel
Guiding channel
The diameter of the guiding elements is always
proposed for change after the pusher changeover
cycle.
Part setup: Number of clamping device openings
Number of clamping device openings
Number of lathe clamping openings during the
machining of one part. Used to prevent undesired
part feed out during clamping opening.
Part setup: Alarm headstock reverse
If the barstock goes backwards when the lathe
clamping device is open, an alarm is activated.
This parameter have to be deactivated if a stopper
is used to positioning the barstock.
5.3. Application parameters
Application: Part feed out with turret
Defines if the lathe turret waits in position or
follows the bar stock displacement during feeding
operation.
To Next Page
Loading...
