SECTION 3.618
While in Programming Mode, select “1AD” to add an Access Code. If you are
not in Programming Mode, please see Section 3.2 to enter Programming Mode.
After pressing “1AD” press “FP” to register a Fingerprint.
Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see
a green LED ring light up on the fingerprint panel on the exterior of Lockly™.
3.6 Adding a Fingerprint (Continued)
Once you’re in Fingerprint Registration Mode
you will see two numbers displayed on keypad.
The top number is your Fingerprint Registration
number, in this example to the left, “1”. The
bottom number will always start with a “6”.
You must successfully scan your fingerprint six (6)
times for it to properly register. Every time you
scan your fingerprint, the number on the bottom
will change, starting from 6 - then 5, 4, 3, 2, 1, until
the fingerprint is successfully registered.
Note: For reference, please keep a record of your
fingerprint registration number to distinguish
whom it was registered to.
To Next Page
Loading...
Need help?
General
