SECTION 3.6 19
3.6 Adding a Fingerprint (Continued)
Scan your finger by lightly placing your designated finger on the sensor until
you hear a beep. Lift your finger and repeat the process slowly until the
digit “6” shown on the screen becomes “1”.
If you have successfully
scanned and registered
your fingerprint, you will hear a long beep, and the
Bluetooth icon will flash green.
PASS will show on the keypad and press OK to exit. If you did not success-
fully register your fingerprint, FAIL will show on the keypad. If FAIL is
displayed, press OK to return to the previous screen to rescan your finger.
For instructions on scanning an optimal fingerprint, please proceed to
Section 3.7.
OK Button
NOTICE
Please make sure your fingers are clean from dirt and oils
before scanning your fingerprint. Make sure the sensor is
also clean by taking a soft cloth and wiping the surface.
To Next Page
Loading...
Need help?
General
