23
www.longer3d.com info@longer3d.com
point. It can rotate the model by holding down the right
mouse, and drag the model by holding down the mouse
wheel.
Delete: delete the support of selected model.
Density: the density of generating support, the bigger value,
more support will be generated. The suggested value is
between about 1.0.
Attaching Point: the diameter of supports that contact model,
the bigger diameter, the stronger support, but harder to spin
off. The suggested value is about 0.6.
Shaft Diameter: the diameter of support column, the larger
value, the stronger support, but more difficult to remove. The
suggested value is about 1.1.
Lift Distance: the distance between the model and building
To Next Page
Loading...
